Airush Amp II Epoxy (Complete) 2019

Article number: 010150060118
Availability: Out of stock

All-round Surf

  • Dedicated all-round surf shape.
  • Flat nose rocker for early planing.
  • High curve outline for maneuverability.

The AMP II was developed directly from our favorite dedicated all-round surf shape, combining a flat rocker for high speed and control, with a higher curve to optimize maneuverability.

The narrower diamond tail is ideal for kiting, as it maintains control at high speed while the wider center and fuller nose work with the low wind performance.

The bottom shape features a single to double concave through the center section. The winger channels introduce more rocker into the tail section for the best way to keep track of the bottom turn.

The AMP II is the ultimate blend of drive and maneuverability, ideal for less powerful surfing and onshore days. Ride it one size smaller for higher wind and flat water boosting or one size bigger for surfing and kiting crossover. The AMP II sets a new paradigm in narrower wave performance, but will surprise you in all conditions.

5'2 "(157cm) 18.5 "(47cm) 2.2 "(5.6 cm) 22.5L (Custom Epoxy Only)

5'4 "(163cm) 19 "(48.6cm) 2.3 "(5.8cm) | 25.4L

5'6 "(168cm) 19.5 "(49.5 cm) 2.4 "(6.1cm) 28L

5'8 "(173cm) 20 "(50.8cm) 2.5 "(6.35cm) 31L


Custom Epoxy

Custom Epoxy offers the flex and feel of a classic surfboard, with the increased durability of the kite specific construction.

We start with a medium-density EPS core (35 Kg / m3, for the tech heads) developed from our premium fused EPS technology. When using a single skin construction, the core is ideal, specifically in the thinner, lower volume boards, such as the Converse.

Covering the core, the laminate has been extensively reinforced to deal with the demands of kiting with up to five layers in the standing area, and a final layer of Innegra under the heels. Innegra is the lightest fiber commercially available (lighter than water) and can dissipate tremendous energy, making it ideal for high impact areas.

Custom EPS offers the flex and feel of a classic surfboard, with the increased durability of the kite specific construction. All custom epoxy surfboards include footstrap inserts.


1: Curve in the hip and tail area for maximum snap off the top.
2: Low tail rocker for speed.
3: Wide center for early planing.
4: Wide point relatively far forward for control at speed.
5: Reduced length to assist maneuverability.
6: Full nose with a large amount of curve for planing and maneuverability.
7: Flat nose rocker for early planing.
8: Tail - 1.5mm Single concave, blending to 1mm Panel V.
9: Mid - 1.8mm Inverted Spiral V.
10: Nose - 1.4mm Spiral V.
11: High apex rail.
0 stars based on 0 reviews
By using our website, you agree to the usage of cookies to help us make this website better. Hide this message More on cookies »